» Featured Products » CNC Spindles & VFDs » CNC Milling Spindle » CNC Milling Spindle Kit 2200W (3.0HP) (1.5HP) (Brushless Motor and Driver), 220VAC

CNC Milling Spindle Kit 2200W (3.0HP) (1.5HP) (Brushless Motor and Driver), 220VAC

Product in stock

Price

$699.95

Loading Updating cart...

CNC Milling Spindle Kit 2200W (3.0HP) (1.5HP) (Brushless Motor and Driver), 220VAC

Product Description

Panel operation parameter setting:

Panel speed adjustment mode:

0-10V Analog speed setting mode:

Port start speed with E-stop mode:

Motor Specification:

CNC Milling Spindle Diagram (657)

Wiring and Setting:

1100/2200W CNC Milling Spindle (696)

Driver:

DC+Driver+Manual (679)

A: KL-2200_BLM Brushless Motor and Driver kit,  220VAC,:

1: KL-2200_BLM Brushless Motor :  2200W (3.0HP) / 6000RPM/ 220VAC, Single phase , up to 6000RPM Brushless Motor, Shaft Size: 18mm
2: KL-2260_BLM Brushless Motor Driver , AC 220VAC  input for 2200W (3HP)

B: KL-1100_BLM Brushless Motor and Driver kit 220VAC,:

1: KL-1100_BLM Brushless Motor :  1100W (1.5HP) / 8000RPM/ 220VAC,Single phase , up to 8000RPM Brushless Motor,  Shaft Size: 15mm
2: KL-1100_BLM Brushless Motor Driver,  AC 220VAC  input

One Year parts Warranty

 

Panel Control:
1.Run     ----------  Bottom left Key
2.STOP------------Top Middle Key
3.Increase ---- --- Top Right Key
4.Decrease ------- Botton Right Key
5:  Configure  ------ Top Left

  • Exchange between panel and 0~10v analog A: Panel operation parameter setting Panel speed settings are as follows three parameters, after the restart into the panel speed mode panel operation mode: (FN000 = d0012, Fn001 = 1, FN010 = 36,FN147=1 Displays the current panel setup speed, After set this, power off and Power on)
  • Analog speed mode: ( FN000 = d0005, Fn001 = 0,FN010 = 3 Displays the actual motor speed, After set this power off and Power on)

0-10v Analog Speed Setting :

The following three parameters, after the restart into the analog speed and use the port to start and reverse speed

  • <Press the Mode key when you see FN000, then press the Set key , you will see d0012, then press the down key to see d0005 ,then press the set key>
  • Fn001 = 0
  • <now press the modekey when you see Fn000 then press the Upkey to Fn001 then press the set key , you will see 1 press the down key to 0, then press the set key>
  • FN010 = 3
  • Displays the actual motor speed , change FN147=0
  • <then now press the modekey when you see Fn000 then press the Upkey to Fn010 then press the set key , you will see 36 press the down key to 3, then press the set key>
  • Step by Step,  then will change into 0~10V use
  • FN220: 1040 ( 0 to 5 VDC Control)
  • FN220: 520   ( 0 to 10 VDC control)
LoadingUpdating...